Standby Mode - Vivanco FMH 6150 Bedienungsanleitung

GB
3. Connect the audio connecting cable to a headphone output, or to a line out or rec.
out output. Set the volume of your audio source to 1/4 to 1/3 of the maximum volume.
4. If the charge indicator doesn't change to red, move the handset back and forth slightly
in the charging shell until the charging contacts snap into place correctly and the
charge indicator changes to red.
5. Insert the supplied batteries as described in the chapter "Using batteries or
rechargeable batteries".
6. Switch on the RF headphone via the on/off switch.
7. Turn the channel selection control on the RF headphone until the transmitter has
been located and the sound you hear becomes optimal. If the transmitter has been
located, the operating indicator on the RF headphone lights up green.
8. Your device is now ready for operation.

Standby mode

The transmitter switches automatically to standby mode if it does not receive any signal
for 2 minutes or if the signal is too quiet. It switches automatically back to transmission
mode as soon as a signal is present again.
Using batteries or rechargeable batteries
Opening the battery compartment
1. To open the battery compartment, carefully pull off the ear cushion from the left side
earshell "L". The battery compartment is located behind this.
2. Insert the batteries or rechargeable batteries (micro, type AAA) into the battery
compartment, observing the correct polarity.
3. Place the ear cushion over the battery compartment again and press it carefully until
it latches.
Charging the supplied rechargeable batteries
1. Switch off the RF headphone.
2. Place the RF headphone in the charging tray with the side marked "L" to the left.
All manuals and user guides at all-guides.com
9