Power Connection; Initial Installation; Select Source; Connect External Devices - AEG CTV 2203 Bedienungsanleitung

ENGLISH
56
Other Antenna Connections
For optimum trouble-free picture quality use a dual shielded 75 ohm antenna cable.
1. Connect a 75 ohm antenna cable to the antenna wall outlet.
2. Connect the other end to antenna input ANT at the rear of the device.
3. In the source menu (press SOURCE button) select ATV.
NOTE:
To be able to watch TV you first have to search for channels ( see "4.5 Initial Installation" on page 56).

4.4 Power Connection

The TV set is designed for AC 100-240V~ 50/60Hz.
• Connect the mains cord to AC-INPUT and a wall outlet.
CAUTION:
Connect all devices before connecting the TV set to mains power supply. The wall outlet must be freely accessible at all
times.

4.5 Initial Installation

When turning the TV set on for the first time a window is displayed to
select the menu language and to start auto scan (Auto-Suche).
1. Toggle the main switch at the right bottom of the device to turn
the TV set on. The window Installationsführer is displayed.
2. Press ENTER to confirm German as OSD language or press the ar-
row buttons / on the remote control and ENTER to select your
language. The item Auto Scan is highlighted.
3. Press ENTER. Press the arrow buttons / to select the country of
your location.
4. Press ENTER twice to start auto scan. This process will take a few
minutes. Progress is displayed on screen.
5. After auto scan is finished channel 1 is shown.
6. After a few seconds the window will disappear or press EXIT to close the window.

4.6 Select Source

5. Connect External Devices

Your TV set features a variety of connectors for different devices (e.g. DVD recorder, PC, camera and set top box).
IMPORTANT! Ensure that your TV set and all devices to be connected are turned off before connection. Observe the user
manuals of devices to be connected.
SCART Connector
The SCART connector at the rear transmits analogue image and sound signals in good quality. Connect here devices such
as VCR, satellite receiver, game console or Pay-TV decoder.
1. In on mode press the SOURCE button. The source menu (connected devices) is dis-
played.
2. Press the arrow buttons / on the remote control or CH +/- on the device to select
the desired source.
3. Press ENTER or VOL +/- on the device to confirm.
NOTE:
Press the EXIT button to exit the menu without changes.