Battery Charging - JBM 53802 Bedienungsanleitung

Unit set
You can chose the suitable unit.
Gas Zero
You can use this option to reset de zero value in the
meter.
To do so, you need to make sure you are in a clean air
environment.
If you are in a clean environment, the value should be
0.
If it shows another value, press the
drift.
Press to save the value.
Press again to return to main menu interface.
Gas Calib
You can use this setting if you need to calibrate the
meter.
First, you need to put the ca-
libration adapter in the meter.
Next, you have to connect the
hose from the ozone tank.
In the calibration setting, enter
the password 8888.
Enter the concentration value
of was that will enter into the
meter (you can check the con-
centration in the bottle tank)
and press NEXT.
As the gas enter into the me-
ter, it will show the concentra-
tion value in the screen.
After the value remains stable
for 2 minutes, press SAVE and
the calibration is done.
NOTE: A flow rate of 500ml/
min. is recommended.
Set time
This setting allows you to change the date and the
time.
Use the buttons to change the values and the
button to save.
ESC
Select ESC to return to the detection mode.
Turn off
To turn off the meter, press
To return to detection mode, press
ALARM INFORMATION
Low alarm
High alarm
Low battery
alarm
button to zero

BATTERY CHARGING

Turn off the detector before charging.
When the battery mark on the screen is full, the char-
ging process is completed.
You can disconnect the charger.
WARNING! During battery charging, the meter can-
not enter in detection mode.
NOTE: Make sure you make a full charge once per
month.
CONTENTS
Ozone meter: 1pc
Calibration cap: 1pc
Charger: 1pc
Instructions manual: 1pc
Suit case packaging: 1pc
· 6 ·
.
.
Tone repetition: Slow.
Visual indicator: Red light flashes
slowly.
Device vibrates.
Tone repetition: Fast
Visual indicator: Red light flashes
fast.
Device vibrates.
When the device is in low battery,
it will give slow short alarm every
minute.
REF. 53802