Safety Instructions - JBM 53802 Bedienungsanleitung

REF. 53802
EN
INSTRUCTION MANUAL
PRODUCT'S PRESENTATION
This ozone meter allows you to determine the content
of ozone in the air.
It can be used after the utilization of an ozone genera-
tor, so you can determine if the ozone level of an area
is harmful to human health.

SAFETY INSTRUCTIONS

Do not shake the device strongly
The detector may not work properly if there is any
high concentration gas interference.
The detector should not be stored or used under
caustic gases presence in the environment.
Do not use under excessive high or low tempera-
ture.
Do not use under excessive humidity or in presence
of electromagnetic field
Clean the dust on the device after long-time without
use. Dust will affect the results.
OPERATION
To power on, press the
then release it.
After self-testing, it will enter to detecting status.
At this time, the display will show the following infor-
mation:
1
5
1. Gas type
2. Concentration value
3. Full Battery
4. Time
5. Temperature
To turn off press the button for 3 seconds.
The buzzer will sound.
When it displays the following images on the screen,
loosen the key.
The detector will turn off.
button for 5 seconds and
3
2
4
· 5 ·
METER CONFIGURATION
Press and release
screen:
Use the buttons to navigate through the menu.
Press the button to select.
Record
It will show previous readings, indicating the date, the
time and the value registered when the high alarm
went off.
To return to normal detection interface, press
To delete the record, press
Low Alarm Set
The low alarm setting will show the percentage of gas
concentration where the low alarm will show off.
To return to menu, press
If you need to change the value, press
Press the buttons to change the settings.
Press to save the selected value.
High Alarm Set
The low alarm setting will show the percentage of gas
concentration where the high alarm will show off.
If you need to change the setting, please proceed as in
the low alarm setting.
button to open the menu
.
.
.
.