Remove The Battery Pack; Operation; Start The Machine; Stop The Machine - GreenWorks GD48BV Bedienungshandbuch

3.5

REMOVE THE BATTERY PACK

Figure 10.
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
4

OPERATION

4.1

START THE MACHINE

Figure 11.
1. Push the On/off button.
2. The machine starts in a low speed.
3. Turn the speed dial forward to increase the speed from 0
km/h to 280 km/h.
4. Push the speed button to increase the speed to 322 km/h.
IMPORTANT
Set the speed to high position when the machine is in the
vacuuming mode.
4.2

STOP THE MACHINE

Figure 11.
1. Push the On/off button.
4.3

LED DIAGNOSTICS

CONDITION LED
Low voltage 1 LED flashes
protection red 5 times.
Over-load pro- 1 LED flashes
tection red 4 times.
The green and
Battery jam pro-
red LED go off.
tection
The unit stops.
Unusual battery The green and
temperature red LED go off.
4.4

OPERATION TIPS

• Make sure that the machine is in good condition.
• Make sure that the tubes and guards are in position.
• Do not point the machine at the person or loose materials
before you start the unit.
• Ear protection is necessary to decrease the risk of hearing
loss related to noise level.
• Obey all applicable laws, regulations, standards and
ordinances.
English
SOLUTION
Start the machine
again or Charge the
battery pack.
Start the machine
again.
Remove the battery
pack for 5 seconds to
set the machine.
When the temperature
of the battery pack de-
creases, the machine
can operate in a good
condition.
5
4.5

OPERATE AS A GARDEN VAC

Figure 12.
1. Hold the machine tightly.
2. Hold the machine in a way the suction pipe is slighty
tilted 5 - 10 cm above the floor.
3. Use a sweeping action to collect light unwanted
materials.
NOTE
Make sure that you install and zip the bag.
NOTE
Use the shoulder strap.
4.6

OPERATE AS A BLOWER

1. Hold the machine tightly.
2. Operate from side to side.
3. Move the machine forward slowly.
4. Keep the collected unwanted materials in front of you.
NOTE
Use rakes and brooms to loosen the unwanted material
before you blow.
NOTE
Use the low speed to move dry items, and high speed to
move heavy items such as large unwanted materials or
gravel.
5

MAINTENANCE

CAUTION
Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
CAUTION
Do not use strong solvents or detergents on the plastic
housing or components.
WARNING
Remove the battery pack from the machine before
maintenance.
5.1

CLEAN THE MACHINE

CAUTION
The machine must be dry. Humidity can cause risks of
electrical shocks.
EN