Description; Purpose; Overview; Safety - GreenWorks GD48BV Bedienungshandbuch

EN
1

DESCRIPTION

1.1

PURPOSE

The machine is used to propel air out of a tube to move
unwanted materials such as leaves in the yard. Some
machines also suck in leaves and small twigs through a
vacuum, and shred them into a bag.
1.2

OVERVIEW

Figure 1 - 13.
Speed dial
1
Speed button
2
On/off button
3
Blower tube
4
Gate
5
Auxiliary handle
6
2

SAFETY

Make sure that you do/obey all safety instructions.
Refer to Safety Manual.
3

INSTALLATION

3.1

UNPACK THE MACHINE

Make sure that you correctly assemble the machine before
use.
• If the parts have damage, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the service
center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with local
regulations.
3.2

ASSEMBLE AS A VAC

Figure 2 - 8.
Vac tube
7
Collection bag
8
Lock button
9
Slot
10
Notched area
11
WARNING
WARNING
WARNING
English
Make sure that the machine is in the OFF position, and the
impellers stop before you attach or remove tubes.
1. Move the front and rear vac tubes together until the lock
button engages.
2. Pull the lock button forward to disengage the gate.
3. Hold the gate open.
4. Put the "wedged" end clip of the vac tube into the rear
clip.
5. Push the "hooked" end clip of the vac tube into the front
clip.
6. Push back the lock button to engage the vac tubes.
You can do the steps above in the opposite sequence to
remove the vac tubes.
7. Put the bag adaptor into the blower outlet. Lock the bag
adaptor with the lock button.
It can be necessary to remove the blower tube or vac tubes
to clean a blocked tube or impeller.
3.3

ASSEMBLE AS A BLOWER

Figure 9.
1. Move the blower tube forward until the notched area
clicks into the slot.
2. Put the concentrator nozzle into the blower tube to lock.
You can use the concentrator nozzle to increase airflow
in tight areas: flower beds, under decks, etc.
3.4

INSTALL THE BATTERY PACK

Figure 10.
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the motor stops before
you install or remove the battery pack.
• Read, know, and do the instructions in the battery and
charger manual.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
4
WARNING
TIP
NOTE
NOTE
WARNING