Epson TM-U950 Bedienungsanleitung Seite 9

2. Insert the check face down, with the
3. Insert the check straight into the inlet,
4. The printer starts drawing the check
5. When MICR reading is complete, the printer ejects the check
6. Remove the check by pulling it straight out (not at an angle).
Cleaning the Optional MICR Mechanism
Clean the MICR head and MICR roller every 6000 passes or once a
month.
Note:
If you encounter frequent MICR reading errors, use the procedure below.
For the MICR head
Use a moistened cleaning sheet, such as PRESAT brand (KIC)
"Check Reader Cleaning Card" or an equivalent commercially
available cleaning sheet.
For the MICR feed roller
Use an adhesive cleaning sheet available from EPSON. Contact
your dealer.
Cleaning procedure
Use this procedure for both cleaning sheets.
1. Load both paper rolls into the printer; then turn off the power.
2. Open the front cover and turn the power back on while holding
3. Press the JOURNAL/SLIP button 3 times.
4. Close the front cover (the SLIP LED flashes).
5. Follow the instructions on the cleaning sheet. You will insert
6. When the sheet is ejected, remove it from the printer; then turn
Downloaded from www.Manualslib.com
MICR characters on the right-hand
side.
using the right edge of the inlet as a
guide, as far as the check will go. See
illustration .
9
in. Let go of the check immediately.
The SLIP LED goes from blinking to on.
and the SLIP LED starts blinking again.
The SLIP LED goes off.
down the JOURNAL/SLIP button.
the cleaning sheet the same way you insert a normal check.
off the power.
manuals search engine
English
9
y
x
TM-U950 User's Manual 7