Troubleshooting - Bestway P3121 Benutzerhandbuch

APP PANEL INSTRUCTION:
1. Click "FULL INFLATE" and the pump will inflate the airbed.
2. Click "FULL DEFLATE" and the pump will deflate the airbed.
3. Click "STOP" and the pump will stop inflating or deflating.
4. Click "MICRO INFLATE" and the pump will inflate the airbed, automatically stopping after 5 sec.
5. Click "MICRO DEFLATE" and the pump will deflate the airbed, automatically stopping after 2 sec.
TROUBLE SHOOTING
Indicator light show
Indicator light flashes slowly
Indicator light is on
Indicator light flashes quickly
Indicator light is off
Indicator light is on when powered
Problems Probable Causes
The pump has been connected
to the wrong band
The pump location is too far
from the router
Set up the wrong Network
Name
The Wi-Fi The WIFI password used during
setup the connection is wrong
is not
The strength of the WIFI signal
successful
is not stable
There is appliance near the
pump or the router that is
creating a signal interference.
Your phone is not connected to
the Wi-Fi network during
registration.
The state of the pump
Waiting to connect to the router
Connected to the router
Lost WiFi signal
Light is damaged & Wi-Fi module has problem
Self-inspection
Solutions
If the router your pump is connected to is dual-band and currently it is not
connecting to a 2.4GHz network, please switch to another band of the same
router (2.4GHz) and try to pair pump again. 5GHz networks are not supported.
Check with your mobile phone if there is full WIFI signal. In case the strength of
the signal on your phone is too low, check where the strength of the WIFI signal
is full on your phone and position the pump in that position.
Start again with the connection procedures and be sure that the network name
is typed correctly.
Start again with the connection procedures and be sure that the password is
correct
1) Check if the router works correctly.
2) Go near the pump and check the signal on your phone.
If the signal strength is not stable, check the condition of your router.
If the signal strength is full, repeat the operation to connect the pump to the
network.
The Wi-Fi connectivity can be interrupted by electromagnetic or other
interferences. Keep the appliance away from other electronic devices that may
cause interferences.
Check if the mobile device is in airplane mode.
Make sure to have the airplane mode deactivated when connecting to the Wi-Fi
network.
6