Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
mains socket. Wait for approxi-
mately a minute, and then switch
on.
IMPORTANT: Do not use the trim-
mer in this mode for more than 20
minutes.
USE OF THE COMB GUIDES
This trimmer is supplied with 2
comb guides.
No.1 - 6mm
No.2 - 10mm
To attach a comb, hold it by the
sides and clip it over the teeth of
the blade. To remove the comb,
simply push off.
ZERO GAP ADJUSTMENT TOOL
IMPORTANT! Only ever attempt
to zero gap the blades using the
adjustment tool, following the ins-
tructions very precisely.
The adjustment tool is required to
adjust the blades to zero gap, to
achieve a closer, more precise cut.
Regular
Zero Gap
REGULAR
ZERO GAP
ZERO GAP
Step 1.
Before placing the blade into the
adjustment tool, use the screwdri-
ver provided to loosen the tension
screws, without removing them
completely from the blade holder.
Step 2.
Place the blade into the adjust-
ment tool in the side labelled 'Zero
Gap'.
Step 3.
Push the blade guide up as far as
the adjustment tool allows, so the
moving blade sits closely with the
top of the adjustment tool. The
blades will now be flush with each
other.
7
Werbung
Inhaltsverzeichnis
