Maintenance & Servicing; Warranty; Technical Specification - Stuart SMP3 Bedienungsanleitung

Maintenance & Servicing
WARNING: Ensure the unit is disconnected
from the mains electricity supply before
attempting maintenance or servicing.
Periodically clean the instrument using a damp
cloth and mild detergent solution. Do not use
harsh or abrasive cleaning agents.
The magnifier lens can be removed from its
retainer and gently cleaned with a damp cloth.
To remove the test block window, slip out the
window retaining circlip. Remove the window
using tweezers and clean with a damp cloth.
Any repairs or replacement of parts MUST be
undertaken by suitably qualified personnel.
Only spare parts supplied or specified by
Barloworld Scientific or its agents should be
used. Fitting of non-approved parts may
affect the performance and safety features
designed into the instrument.
If in any doubt, contact the Technical Department
of Barloworld Scientific or the point of sale.
Spares and Accessories
For a comprehensive list of parts required by
service engineers conducting internal repairs,
please contact the Sales Department of
Barloworld Scientific quoting both the model and
serial number.

Technical Specification

Number of samples
Temperature range
Temperature resolution
Temperature accuracy
Display
Sensor
Ramp rate
Memory storage
Dimensions (wxdxh)
Net weight
4
Three
Ambient to 360°C
0.1°C
± 0.5°C at 20°C
± 1.5°C at 300°C
Alphanumeric LCD
PT100
0.5° to 10°C minute
8 x temperature readings per sample tube tested
180 x 260 x 300 mm
3.2 Kg

Warranty

Barloworld Scientific Ltd. warrants this instrument
to be free from defects in material and
workmanship, when used under normal
laboratory conditions, for a period of two (2)
years. In the event of a justified claim Barloworld
Scientific will replace any defective component or
replace the unit free of charge.
This warranty does NOT apply if damage is
caused by fire, accident, misuse, neglect,
incorrect adjustment or repair, damage caused by
incorrect installation, adaptation, modification,
fitting of non-approved parts or repair by
unauthorised personnel.
Correspondence
Barloworld Scientific Ltd.
Stone, Staffordshire ST15 0SA
United Kingdom
Tel: +44 (0) 1785 812121
Fax: +44 (0) 1785 813748
e-mail equipment@barloworld-scientific.com
www.barloworld-scientific.com