Networks And The Internet; Configuring Your Network Connection - Samsung HT-E4200 Bedienungsanleitung

Settings

Networks and the Internet

When you connect this product to a network,
you can use network based applications and
functions such as Smart Hub and BD-LIVE, and
upgrade the product's software through the
network connection. For more information about
accessing and using Internet services, see the
Network Services chapter of this manual on pages
49~51. Instructions for configuring the network
connection start below.

Configuring Your Network Connection

Before you begin, contact your ISP to find out
if your IP address is static or dynamic. If it is
dynamic, and you have a wired or wireless
network, we recommend using the Automatic
configuration procedures described below.
If you are connecting to a wired network, connect
the product to your router using a LAN cable or
Samsung Wireless LAN Adapter (sold separately)
before you start the configuration procedure.
If you are connecting to a wireless network,
disconnect any wired network connection before
you begin.
To begin configuring your network connection,
follow these steps:
1 · In the Home screen, select Settings, and
then press the E button.
2 · Select Network, and then press the E
button.
3 · Select Network Settings, and then press the
E button.
4 · Go to the instructions for Wired networks
starting below or the instructions for Wireless
networks starting on page 31.
Wired Network
K
Wired – Automatic
After following Steps 1 to 3 above:
1 · Select Start in the Network Settings screen,
and then press the E button. The product
detects the wired connection, verifies the
network connection and then connects to the
network.
30
|
English
HT-E4200_XU_0223.indd 30 HT-E4200_XU_0223.indd 30
Downloaded from www.Manualslib.com manuals search engine
K
Wired - Manual
If you have a static IP address or the Automatic
procedure does not work, you'll need to set the
Network Settings values manually.
After following Steps 1 to 3 above:
1 · Select Start in the Network Settings screen,
and then press the E button. The Network
Status screen appears. The product attempts
to verify the network connection and fails.
Network Settings
Wired network connection failed.
MAC Address XX:XX:XX:XX:XX:XX
IP Address
Subnet Mask
Gateway
DNS Server
Unable to connect to the network. Try the following:
check if your IP address is set correctly in IP Settings.
Contact your Internet service provider for more information.
2 . Select IP Settings on the right of the screen,
and then press E button.
The IP Settings screen appears.
3 . Select the IP Mode field, and then set it to
Manual.
4 · Use the number keypad on your remote to
enter the Network values. Use the ▲▼◄►
buttons on the remote to move from entry
field to entry field.
| NOTE |
\ You can get these values from your Internet provider. You
can also view these values on most Windows computers.
For instructions, see "Getting the Network Settings
Values." on next page.
5 · When done, highlight OK, and then press
E button. The product verifies the network
connection and then connects to the
network.
0.0.0.0
Previous
0.0.0.0
IP Settings
0.0.0.0
0.0.0.0
Retry
OK
2012-02-24 오전 2:15:05 2012-02-24 오전 2:15:05