ASROCK 990FX Extreme9 Handbuch Seite 26

Downloaded from www.Manualslib.com
2.7 Jumpers Setup
The illustration shows how jumpers are
setup. When the jumper cap is placed on
pins, the jumper is "Short". If no jumper cap
is placed on pins, the jumper is "Open". The
illustration shows a 3-pin jumper whose
pin1 and pin2 are "Short" when jumper cap
is placed on these 2 pins.
Jumper
Clear CMOS Jumper
(CLRCMOS1)
(see p.2, No. 29)
Note: CLRCMOS1 allows you to clear the data in CMOS. The data in CMOS in-
cludes system setup information such as system password, date, time, and
system setup parameters. To clear and reset the system parameters to de-
fault setup, please turn off the computer and unplug the power cord from the
power supply. After waiting for 15 seconds, use a jumper cap to short pin2
and pin3 on CLRCMOS1 for 5 seconds. However, please do not clear the
CMOS right after you update the BIOS. If you need to clear the CMOS when
you just fi nish updating the BIOS, you must boot up the system fi rst, and then
shut it down before you do the clear-CMOS action.
The Clear CMOS Switch has the same function as the Clear CMOS
jumper.
26
ASRock 990FX Extreme9 Motherboard
manuals search engine
Setting
Default Clear CMOS