Network Setup [Nws]; Network Reset [Nwr] - Canton Smart Amp 5.1 Bedienungsanleitung

To execute the reset, keep "Reset All" [YES] and confirm with the "OK" button. The display then shows [YES] to confirm the reset proce-
6
dure, the OSD shows "Please Wait".
After some seconds the Amp 5.1 reboots. During this procedure the display flashes [ON] and the LED flashes green fastly.
7
To perform the reset using the touch keys on the top of the Amp 5.1 please proceed as follows:
Power up your Amp 5.1 using the Power" " " key.
1
To enter the menu, press the input select key "
2
Use the "+" or "-" key to navigate to the menu System Setup [SYS] and confirm with the Play/Pause button " ".
3
Select the function Factory Reset [RES] and confirm with the Play/Pause button " ". The display shows [YES], the OSD indicates "Reset
4
All".
To cancel the reset procedure, press the input select key "
5
the menu.
To execute the reset, keep "Reset All" [YES] and confirm with the Play/Pause button " ". The display then shows [YES] to confirm the
6
reset procedure, the OSD shows "Please Wait".
After some seconds the Amp 5.1 reboots. During this procedure the display flashes [ON] and the LED flashes green fastly.
7

3. Network Setup [NWS]

The third menu item of the Main menu includes the setup of the network connection. It contains the two items:
• Network Connection
• Network Reset [NWR]
Network Connection [NWC]
At this menu the connection way of the WiFi module is set. The module can be connected Wireless [WLA] (default) or Wired [ETH] using the
Ethernet port of the Smart Amp 5.1.
To change the connection way from wireless to wired or contrary, do the following:
To enter the menu, press the "M" button.
1
Use the " " or " " button to navigate to the menu Network Setup [NWS] and confirm with the "OK" button.
2
Confirm the first item Network Select [NWC] with the "OK" button.
3
Select the desired connection way using the "+" or "-" key, [WIF] for a wireless resp. [ETH] for a wired network connection and confirm
4
" until the display shows [SPS] and the Main Menu is entered.
[NWC]
". The display shows [RES] again. Press this key additional two times to exit
English
3 1 05