Cleaning And Care/Disposal - Gastros InductWarm 200 Built-in Betriebsanleitung

Cleaning and Care / Disposal
Cleaning tips

First, use a scraper to remove all large pieces of dirt and food leftovers from the warming surface.

Then squeeze a few drops of a suitable cleaning product on to the cold surface and rub it in with kitchen
paper or a clean cloth.

Then wipe down the warming surface with water and rub it dry with a clean cloth.

Clean your warming surface regularly, preferably after each use.
Daily Cleaning
For cleaning: Switch off the InductWarm
temperature before starting to clean.
WARNING: Do not use steel wool or sharp objects. Your induction warming device is not splash-water
resistant. Therefore, do not use running water or steam to clean it. To remove dirt and deposits
on side walls, you can use standard pH-neutral cleaning products based on non-ionic and
anionic ten sides and mild organic solvents such as alcohol and glycols. Finally, remove all
cleaning product residue, wipe down the cleaned surfaces with water, and rub dry with a dry
cloth.
Disposal
This product must be disposed at the recycling centre of electrical and electronic equipment. It must not be
disposed of household or normal waste. With the properly disposing you will help prevent potential
environmental damage or health hazards. For more information on recycling the product, contact your local
municipal office or your waste disposal service.
Devices intended for disposal must not be operated further.
WARNING: The device consists of electrical, electromechanical and electronic components. There are no
batteries used.
WARNING: The owner and the operator are responsible for the proper and safe disposal of the device.
®
200 device. Wait until the InductWarm
®
200 device has cooled to hand
35