Operation Of The Cooler - Simfer SYD 160 MD DC Bedienungsanleitung

tion instructions. Use only genuine Simfer spare parts.
Non-genuine spare parts may cause risks for you and may damage
your product.
Place your product where you desire. Consider the placing rules spec-
ified in the manual during placement.
Level your product laterally and vertically with a spirit level. Perform
the levelling procedure with the adjustable legs on the front lower part
of your cooler.

OPERATION OF THE COOLER

Rules for Electrical Connection
Your appliance shall operate when you plug it to an outlet.
CAUTION!
Do not plug your appliance to a multi-socket or do not use an exten-
sion cord.
Your product is not equipped with an on/off switch.
Do not allow the cables of your product connected to the mains to
contact hot surfaces. Outlet that shall be used shall always be ground-
ed. The outlet to be used should also be protected with a proper fuse
with a rating of 1016 A minimum. Always get support from our author-
ized service or a qualified electrician for the fuse that shall be installed
on the electrical installation where the outlet is connected. (Figure 6)
The voltage and frequency of mains power should be the same as the
values specified on the label on the inner surface of your appliance. If
mains power is far below or above the specified value, have the desired
voltage by using a voltage regulator.
You can get help from a qualified electrician.
Do not put the cable of your product on passage routes. These may
cause injury to you and damage to your cooler.
27