Epson TM-L90 Bedienungsanleitung Seite 6

English
(*) May not be included with the printer
Installing Horizontally or Vertically
You can install the printer horizontally (with the paper exit on top) or
vertically (with the paper exit at the front) either on a flat surface or by
hanging it on a wall (using the optional hanging bracket set, WH-10).
Both the horizontal and vertical positions are shown below.
When you install the printer horizontally, attach
the control panel label and position the roll paper
near end sensor as shown in the illustrations. To
move the sensor, follow these steps.
1. Loosen the screw with a coin or similar tool
2. Push the lever gently as far as it will go.
3. Turn the tab (in the direction of the arrow in the illustration) while
4. Secure the screw and make sure
Note:
To hang the printer on the wall, see the
Wall Hanging Bracket Set Installation
Manual provided with the WH-10 for
instructions.
4 TM-L90 User's Manual
Downloaded from www.Manualslib.com
Control panel label used for horizontal installation
Paper roll spacer
Paper exit guide for horizontal installation
Screw for installation of the paper roll spacer
Hexagonal lock screws (2 pieces) (only for the serial interface)
AC adapter (*)
Usage Precautions for the Power Unit (*)
and turn it at least 3 or 4 times.
pushing the lever until it clicks into place in hole A.
the lever moves smoothly.
manuals search engine
tab
screw
A