Audiovox UV 8 Bedienungsanleitung Seite 53

Parameter Adjustment Procedure
1. Enter Picture Quality Setting Mode:
Press the PIC button (24) on the remote control or the PIC/AS/PS button (3) on the monitor.
2. Select Item to Set:
Press the AUDIO button (5) on the control panel to select "BRIGHT" or "CONTRAST".
3. Set Parameters:
Press the +/– buttons (15, 16) on the remote or turn the rotary encoder (5) on the control panel.
4. Exit Picture Quality Setting Mode:
Press the PIC button (24) on the remote control or the PICTURE/AS/PS button (3) on the monitor
Parking Brake Inhibit
• When the "PRK SW" cable is connected to the brake switch, the display on the TFT monitor will display video only
when the vehicle brake is applied.
• Parking brake function is overridden when the video source is set to CAMERA.
• When the parking brake inhibit is active, the front monitor displays "Parking Is On", preventing the driver from watching
content while driving. Rear video screens are not affected.
Monitor Movement Mechanism
If an obstruction occurs in the monitor path, the following protective measurements can be executed to prevent
damage to the mechanism or monitor:
After the protective procedure is executed, normal operation is resumed by pressing the OPEN button (1) or
disconnecting and reconnecting the power.
54
Downloaded from www.Manualslib.com manuals search engine