Trueshopping CT15AMBCM Bedienungsanleitung Seite 7

high charging voltages. To minimize risks, disconnect the battery from the vehicle before
using this mode.
Using 13.6V SUPPLY (Hold & Press)
This mode converts the charger to a constant voltage, constant current DC power supply.
When the charger is not connected with battery, it can be used to power 12VDC devices.
Prior to use, read your 12VDC device manual to determine if it is suitable for use with this
mode. As a power supply, it can also be used to retain a vehicle's on-board computer
settings during battery repair or replacement. 13.6V Supply Mode provides 13.6V at 9.5A
with overload protection at 10A (Max). Both spark proof and reverse polarity protection
are disabled in this mode. Do NOT allow the positive and negative battery clamp to touch
or connect to each other as the charger could generate sparks.
Using 12V JUMP CHARGE (Press)
USE THIS MODE WITH FULL ATTENTION AS THE CHARGING CURRENT IS 20A.
This mode is for 12-volt LEAD-ACID batteries only. To operate JUMP CHARGE, the
charger must be connected to a 12V battery with the battery clamps connected. Press the
Jump Charge button to begin jumpstarting. For optimal results, allow JUMP CHARGE to
complete its 5-minute charge. After 5-minute jump charge, the charger will automatically
enter Standby Mode, whether 100% battery level indicator is illuminated or not, and you
are ready to start your vehicle. If unsuccessful when starting your vehicle, let the battery
rest for 15 minutes and try JUMP CHARGE again. Most vehicles will start with one (1)
JUMP CHARGE, but larger vehicles with dual battery systems, may require an additional
JUMP CHARGE. Do not use jump charge more than two (2) times within a 24-hour period.
If two (2) jump charges cannot successfully start your vehicle, have your battery replaced
or evaluated by a local battery store.