Learn Mode; Note-On Command; Program-Change Command; Re-Trigger - Spectral Audio Neptune Bedienungsanleitung

7.2 Learn mode

The Learn mode is accessed by pressing the LEARN key (at least during 3 sec) and is visualised by the
intermitting GATE/LEARN indicator. In this mode, the MIDI parameters such as reference sound and MIDI
channel are determined. In the Learn mode, the following MIDI commands are significant. After receiving one
of these MIDI commands, the GATE/LEARN indicator extinguishes and the Neptune goes into the normal
operating mode. If several parameters are to be changed, then the Learn mode is to be selected several
times. The parameters set are not lost when the unit is switched off. If you operate the LEARN switch once
more, you will leave the Learn mode without any changes.
7.2.1 Note-On Command (key is pressed):
The MIDI channel of the incoming note command is accepted as the new MIDI receiving channel (=MIDI
channel setting). The pitch (MIDI note number) is accepted as the reference note for the lowest possible
tone (=transport function). On the sequencer, select the channel on which it is intended to keep the Neptune,
press the LEARN key and activate the lowest key on the master keyboard. The absolute pitch is dependent
on the setting of the tuning regulators.
7.2.2 Program Change Command:
With this command, the link-up of the controller data and the velocity can be determined on the Neptune.
Furthermore, the re-trigger function can be switched on/off and the note priority can be determined.
The following program change commands are carried out in the normal operating mode, but they will get lost
if you switch off. The changes will however be saved if the Neptune is in the Learn mode when receiving
these commands.
Prog. Effect
1 - Filter dynamic operation is off
2 - Filter dynamic operation is on
3 - The re-trigger function is off
4 - The re-trigger function is on
5 - Filter TB303 Velocity mode is off
6 - Filter TB303 Velocity mode is on
7 - Highest note priotity
8 - Last note priority
Note: The Filter dynamic operation, the Filter TB303 Velocity mode and the volume dynamic operation as
well as the re-trigger function can be simultaneously in switched- on position.

7.3 Re-trigger

When the re-trigger function is switched on, the envelope will be re-initiated upon Legato (If a key is pressed
whilst another key is already pressed, this is called Legato).
3D J H  
Factory setting
X
X
X
X