Filter Dynamic Operation; Filter Tb303 Velocity Mode; Notes; Registered Trade Marks - Spectral Audio Neptune Bedienungsanleitung

7.4 Filter Dynamic Operation

Dynamic operation signifies that the cut-off frequency (filter dynamic operation) is dependent on the velocity
value of the note. The velocity value is actually multiplied with the controller value.
Filter dynamic operation On
Filter dynamic operation Off

7.5 Filter TB303 Velocity mode

If the Filter TB303 Velocity mode is On and the velocity value is smaller than 64, the original velocity value
will be used. If the value received is bigger than 64, the velocity value will be set at the maximum of 127. In
this way the Accent function of the TB303 can be simulated.
This effect will only be audible if the filter dynamic operation is on.

8. Notes

8.1 Registered trade marks

TB303 is a registered trade mark of the Roland Inc. Company, Japan

8.2 Software service via Internet

Our homepage offers:
- downloading of the latest system software (EPROM)
- downloading of various mixermaps for your sequencer software
Spectral Audio, Stockeristrasse 1, CH-6344 Meierskappel, Switzerland
Email: spectralaudio@swissonline.ch
: Cut-off frequency = Controller 2 * velocity value
: Cut-off frequency = Controller 2
Tel. +41 41 790 49 00
3D J H  
http://www.spectralaudio.ch