Axor Citterio 39010003 Gebrauchsanleitung, Montageanleitung Seite 2

EN 0 2
S A F E T Y N O T E S
Gloves should be worn during installation to prevent
crushing and cutting injuries.
The product may only be used for bathing, hygienic
and body cleaning purposes.
The hot and cold supplies must be of equal pressures.
I N S T A L L A T I O N I N S T R U C T I O N S
⁄ Prior to installation, inspect the product for transport
damages. After it has been installed, no transport or
surface damage will be honoured.
⁄ The pipes and the fixture must be installed, flushed and
tested as per the applicable standards.
⁄ The plumbing codes applicable in the respective
countries must be observed.
⁄ If the instantaneous water heater causes problems or if
you wish to increase the water flow, the EcoSmart
(flow limiter) located behind the aerator can be
removed.
T E C H N I C A L D A T A
This mixer series-produced with EcoSmart
Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature:
Recommended hot water temp.:
Thermal disinfection:
The product is exclusively designed for drinking water!
S Y M B O L D E S C R I P T I O N
Do not use silicone containing acetic acid!
D I M E N S I O N S (see page 06)
F L O W D I A G R A M (see page 06)
 with EcoSmart
 without EcoSmart
S P A R E P A R T S (see page 07)
C L E A N I N G (see page 05)
O P E R A T I O N (see page 05)
Hansgrohe recommends not to use as drinking
water the first half liter of water drawn in the
morning or after a prolonged period of non-use.
T E S T C E R T I F I C A T E (see page )
A S S E M B L Y (see page 04)
® (flow limiter)
max. 1 MPa
0,1 - 0,5 MPa
(1 MPa = 10 bar = 147 PSI)
max. 70°C
max. 70°C / 4 min
®
®
®
1,6 MPa
65°C