Electrical Specifications - RC4WD 1/18 Gelande II RTR Truck Bedienungsanleitung

XR2 Ultimate Micro ESC/Receiver
1. ESC/Receiver Features
Type
Servo Port
BEC For Servo
Battery
2. ESC/Receiver
Status
TX Off
Normal Operation: LiPo Mode
Normal Operation: NiMH Mode
3. Selecting Battery Type
During normal operation, hold the key for 5+ seconds until LED change status. Now battery type is changed and
saved in the memory.

4. Electrical Specifications

Description
Low Voltage Cut-off (NiMH)
Low Voltage Cut-off (LiPo)
Max Battery Voltage
Max Continuous Current
Max Peak Current
Thermal Protection
Stall Protection
BEC
XR2 Ultimate Micro Radio
1. Transmitter Features
Type
2 Channel System
7.2V NiMH or 2S LiPo, JST connector (Use setup key to select battery type)
LED
LED Off: If after 4 sec with no TX
detected, it will flash 2 times repeatedly
to indicate loss of signal.
LED Solid On
LED Flashing Quickly
4V (Motor will stop once battery voltage below this value)
6.6V (Motor will stop once battery voltage below this value)
5V, 1A with Thermal and Over Current Protection
2.4GHz, Frequency Hopping, FHSS
Programmable Steering End-points by Setup Key
Programmable Throttle End-points by Setup Key
28
2.4GHz RX with Crawler ESC
Standard 3 Pin Servo Port
5V,1A
To select battery type, See section 3
To select battery type, See section 3
Specifications
9V
3.5A
6A
110˚C
By current limit – 3A
Adjustable Steering Trim
Adjustable Throttle Trim
Dual Rate Steering
Low Battery Indicator LED
RC4WD 1/18 Gelande II RTR Truck
Remark