Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3. After charging has been completed, re-
move the battery pack from the charger
and connect it to the tool. Disconnect the
charger from the power source when not
in use.
NOTE:
Use under extremely hot or cold con-
ditions will reduce operating capacity
per charge.
[Battery Pack]
For Appropriate Use of
Battery pack
Li-ion Battery pack
•
For optimum battery life, store the Li- ion bat-
tery pack following use without charging it.
•
The ambient temperature range is between
0°C (32°F) and 40°C (104°F). If the battery
pack is used when the battery temperature
is below 0°C (32°F), the tool may fail to
function properly.
•
When battery pack is not in use, keep it
away from other metal objects like: paper
clips, coins, keys, nails, screws, or other
small metal objects that can make a con-
nection from one terminal to another.
Shorting the battery terminals together may
cause sparks, burns or a fire.
•
When operating the battery pack, make
sure the work place is well ventilated.
Battery Pack Life
The rechargeable batteries have a limited
life. If the operation time becomes extreme-
ly short after recharging, replace the bat-
tery pack with a new one.
Battery Recycling
ATTENTION:
For environmental protection and recy-
cling of materials, be sure that it is dis-
posed of at an officially assigned loca-
tion, if there is one in your country.
[Battery Charger] Charging
Common Cautions for the Li-
ion/Ni-Mh Battery Pack
NOTE:
• When a cold battery (of about 0°C
or less) is to be charged in a warm
room, leave the battery in the room
for at least one hour and charge it
when it has warmed up to room tem-
perature. (Failing to do so may result
in less than a full charge.)
• Cool
charging more than two battery
packs consecutively.
• Do not insert your fingers into con-
tact hole, when holding charger or
any other occasions.
CAUTION:
To prevent the risk of fire or damage to
the battery charger.
• Do not use power source from an en-
gine generator.
• Do not cover vent holes on the charger
and the battery pack.
• Unplug the charger when not in use.
Li-ion Battery Pack
NOTE:
Your battery pack is not fully charged at
the time of purchase. Be sure to charge
the battery before use.
Battery charger
1. Plug the charger into the AC outlet.
NOTE:
Sparks may be produced when the plug
is inserted into the AC power supply, but
this is not a problem in terms of safety.
2. Slide the battery dock cover back to allow
insertion of the Li-ion battery pack.
• Verify that the cover is locked se curely
in place.
-9 -
down
the
charger
when
Werbung
Inhaltsverzeichnis
