Klarstein Thermaxx Retroheat Handbuch Seite 19

Timer
1. Regulate the time of timer according to the clock by turn it clockwise (DO NOT
TURN IT COUNTER CLOCKWISE)
2. The timer has a small swich,the function is as follow:
I= Unit is always On;
3. Set the timer to position.There are 48 small plastic pins on the timer,each
correspond to 20 minutes interval.Push ourward the pins corresponding to the time
you want the heater to turn ON and push inward the pins corresponding to the time
you want the heater to turn OFF.
4. The pilot light will be on when the timer is set to ON position or the timing function
is activated.
Notes
• Do not use the timer function unattended.
• The heater will not operate if timer is set to the
Activated according to the times required.
• If the heater looses its electricity supply, e.g. Switched off at the mains socket or in
the even of a power failure, the time should be reset after the power on again.
• The pilot light will be on when the timer is set to ON position or the timing function
is activated.
open contact
closed contact
= Timer function is ON
position and the pins are not
EN
19