Fitting Instructions - AUTO-HAK R30 Montageanleitung

FITTING INSTRUCTION
Clamp mark
in acc. with Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
9
7
A
12
11
This towing hitch is designed to assembly in following cars:
FIAT STILO 3/5 doors, produced since 2002 till 2006, catalogue no. R30
and is prepared to tow trailers max total weight 1400 kg and max vertical
load 60 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towing hitch depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towing hitch should be install in points described by a car producer. Before
installation the towing hitch please look at the page 264 of the car instruction.
A
6
4
1
10
3
5
From manufacturer
1. Remove the rear bumper.
2. Outside the left and right chassises drill two holes ø11mm in each ones (see fig.
below).
8
12
11
3. Position the bracket (pos. 5 – the left side) and brakcet (pos. 4 – the right side) at the
earlier drilled holes and fix with the side fish-plates – pos. 6 and 7 (put it earlier into
12
the chassis). Then through the holes (pos. A) of the brackets (pos. 4 and 5) drill holes
ø11mm and fix with the fish-plates cpl. – pos. 8 and 9 (put it earlier into the chassis
also).
2
4. Position the main bar of the towing hitch (pos. 1) and fix with bolts M12x35mm (pos.
11).
5. Mount the bumper.
6. Position the ball of towing hitch (pos. 2) with socket plate (pos. 3) and fix with
M12x75mm (pos. 10) bolts from the towing hitch accessories.
7. Tighten all nuts and bolts according the torque shown in the table.
8. Connect the electric wires according to the instructions of the car.
9. Complete the paint cover of towing hitch (during the mounting paint cover could be
destroyed).
After install the towing hitch you should get adequate note in registration book (at
authorised service station).The car should be equipped with:
•
Indicators
•
Tow mirrors
After 1000km check all bolts and nuts. The ball of towing hitch must be always
kept clear and conserve with a grease.

Fitting instructions

Torque settings for nuts and bolts (8,8):
M 8 - 25 Nm M 10 - 55 Nm
M 12 - 85 Nm M 14 - 135 Nm
NOTE