Designated Use; Operating Conditions - H-tronic HT8S Bedienungsanleitung

1. DeSiGnaTeD uSe

! suitable remote switch receiver (or a consumer con-
nected to it) can be switched on or off wirelessly by
using the remote control. The radio transmitter is ope-
rated with a CR2032 battery.

2. oPeraTinG conDiTionS

This product fulfills all legal, national and European
requirements. All company names and product
descriptions contained are trademarks of the respective
owner. All rights reserved.
– Hand transmitters do not belong in children's hands!
– Hand transmitters may only be used by persons who
have been instructed on how to use them!
– The hand transmitter must be operated with visual
contact to the object!
– The handheld transmitter must be protected from
direct sunlight!
– The hand transmitter must be protected from moisture
and dust. If this point is not followed, a malfunction
can be caused by moisture within the device! - The
permissible ambient temperature (room temperatureis
–20 ° C and +55 ° C during operation.
Local conditions can affect the range of the remote
control.
3. BaTTerY inSTallaTion /
BaTTerY eXcHanGe
A CR2032 battery is included in the delivery which is
already in the battery compartment.
– Open the battery compartment of the radio mini
transmitters by carefully prying apart the two housing
halves (e.g. with a fingernail). The two housing halves
are only screwed together. Do not use force! Insert a
CR2032 battery with correct polarity. The positive
pole of the battery should point outwards, towards
you.
– Place the housing cover back on and screw the two
housing halves together carefully. Do not use force.
– A battery change is necessary if the range of the mini
radio remote control decreases noticeably or the LED
no longer lights up when the button is pressed.
noTeS on THe BaTTerY
– Batteries do not belong in the hands of children.
– Do not leave batteries lying around openly, there is
a risk of them being swallowed by children or pets. If
swallowed, seek medical advice immediately.
– Leaking or damaged batteries can cause burns if
they come into contact with the skin. In this case, use
suitable protective gloves.
– Batteries may not be short-circuited, disassembled or
thrown into a fire. There is a risk of explosion!
– Conventional non-rechargeable batteries may not be
charged. There is a risk of explosion! - Pay attention to
the correct polarity when inserting the battery
(note plus / + and minus / -)
4. TranSmiTTer SeTTinGS:
The device has six selectable modes of operation
(factory setting 0) which are programmed when the
battery is put in. To change the default settings continue
with the following steps:
1.
Take the battery out the battery holder.
2.
Press any key for one second to discharge the buffer
capacitor in the device and erase previous settings.
3.
Select a mode: hold down the appropriate key (1-5)
and insert the battery into the device. If no key is
pressed when inserting the battery factory settings
(mode 0) will be installed.
4.
Release the button.
THe FollowinG PreProGrammeD