Philips HD6596 Bedienungsanleitung Seite 10

English
10
7 Open the lid of the filter holder.
8 Put a paper filter size 102 in the filter holder. Make sure that you fold the sealed edges to ensure
that the paper filter stays upright during brewing (Fig. 15).
9 Use the measuring spoon to put the required amount of pre-ground coffee in the filter (Fig. 16).
Tip: Use one measuring spoon of pre-ground coffee for each cup. Use a heaped measuring spoon
for strong coffee and a level measuring spoon for mild coffee.
10 Close the lid of the filter holder.
11 Slide the insulated jug on the platform of the machine (Fig. 17).
12 Press the jug button to start the brewing process (Fig. 18).
-
The light in the jug button starts flashing and the brewing process starts. (Fig. 19)
Note: If the jug button and the CALC light start flashing alternately during heating up and brewing
(Fig. 20), you need to descale the machine (see 'Descaling the machine').
-
When all the water from the water reservoir has passed through the filter, the light in the jug
button goes out and the machine switches off automatically.
13 You can now remove the insulated jug from the machine (Fig. 21).
14 Remove the filter holder from the insulated jug (Fig. 22).
Tip: You can place the filter holder on the drip tray to prevent coffee from leaking onto your
worktop while you pour out coffee from the jug (Fig. 23).
15 Place the jug lid on the insulated jug and turn it to the keep-warm position (closed lock symbol)
(Fig. 24).
16 Push the lever of the jug lid to pour coffee into one or more cups (Fig. 25).
Brewing pod coffee
Brewing one cup of pod coffee
1 Fill the water reservoir with clean cold water up to the MAX indication and put it back onto the
machine (Fig. 5).
Note: The MIN indication on the water reservoir indicates the minimum amount of water required
for brewing pod coffee. Always fill the water reservoir beyond the MIN level.
2 Put the plug in an earthed wall socket.
3 Open the lid of the machine by moving the lever upwards (Fig. 11).
4 Place the drip tray on the platform of the machine (Fig. 26).
5 Place one pod in the 1-cup pod holder with the convex side pointing downwards (Fig. 27).
Note: Make sure that the pod holder is clean and the sieve in the center is not clogged, e.g. with
loose coffee grounds.
Note: Make sure that the coffee in the pod is distributed evenly and press the pod lightly into the
pod holder.
6 Place the 1-cup pod holder in the machine and close the lid (Fig. 7).
7 Place a cup on the drip tray (Fig. 28).
8 Press the 1-cup button to brew coffee. (Fig. 29)
-
The button starts flashing and the machine starts heating up (Fig. 30).
Note: If the 1-cup button and CALC light start flashing alternately during heating up and brewing
(Fig. 31), you need to descale the machine (see 'Descaling procedure ').