Fanaway CLASSIC Installationsanleitung Seite 12

Fanaway Classic Installation Instructions
WOBBLE:
NOTE: ceiling fans tend to move during operation due to the fact that they are mounted on a rubber
grommet. If the fan was mounted rigidly to the ceiling it would cause excessive vibration. Movement of a
few centimetres is quite acceptable and DOES NOT suggest any problem.
TO REDUCE THE FAN WOBBLE: Please check that all screws which fix the mounting bracket and down
rod are secure.
BALANCING A WOBBLING CEILING FAN:
For your convenience, a Balancing Kit is included; please follow this procedure when balancing the fan:
1) Install the fan without the light kit before balancing the fan.
2) Define the base plate into four areas (point A, B, C and D).
Use one weight from the balance kit to lightly stick on the
edge of the base plate (point A), if the wobble worsens, then
take off the balance kit and lightly stick it on the opposite side
(point C); if the wobble is worse, then go to the adjacent point
B or D, if the wobble gets lessens, then securely stick on the
weight at this location on the base plate.
3) After balancing the fan, assemble the light kit to the light base.
NOISE:
When it is quiet (especially at night) you may hear occasional small noises. Slight power fluctuations and
frequency signals superimposed in the electricity for off-peak hot water control, may cause a change in
fan motor noise. This is normal. Please allow a 24-hour "breaking -in" period, most noises associated
with a new fan disappear during this time. All electric motors are audible to some extent. Please note that
this is not a product fault, and as such is not coverd under warranty.
CARE AND CLEANING:
1) Periodic cleaning of your ceiling fan is the only maintenance required. Use a soft brush or lint free
cloth to avoid scratching the paint finish. Please turn OFF electricity power when you do so.
2) Do not use water when cleaning your ceiling fan. It could damage the motor or the blades and create
the possibility of an electrical shock.
3) The motor has a permanently lubricated ball bearing so there is no need to oil.
NOTE: Always turn OFF the power and disconnect the female plug 1 and male plug 1 before attempting
to clean your fan.
12 |P a g e
AFTER INSTALLATION