Programming (P7) - cefar ifc Gebrauchsanweisung

PROGRAMMING (P7)

8
You program in program 7 yourself
using the diagram below:
1. Switch the stimulator on with
2. Press C. The stimulator goes automa-
tically into programming mode for
P7.
3. Follow the diagram below. Select all
settings for the right channel using
Confirm all selections with C.
and

The diagram shows the lowest and
highest values you can set for each
parameter.
Interference (IFC)
Treatment frequency 1
1–150 Hz
Treatment frequency 2
1–150 Hz
Vector scan
0%, 40% or 100%
2470-200509_CEFAR_IFC_manual_inlaga_outline.indd
.
Prg time 0–60 min.
8
4. When you are done programming,
start stimulation with
channel.
Note: The modulation time is always 6
seconds. If you do not want modulated
stimulation, set treatment frequency 1
and 2 the same.

(0 = endless)
2005-09-14, 15:18
for each

Premodulated (PrE)
Treatment frequency 1
1–150 Hz
Treatment frequency 2
1–150 Hz