LAZER LINK Bedienungsanleitung Seite 4

UK
Congratulations and thank you for choosing the
Lazer Link, the innovative handfree Bluetooth
system especially designed for the Lazer helmets
to allow easy and safe audio communication in
motion.
The Lazer Link is compatible with all audio
Bluetooth
®
A2DP profiles (Mobile, GPS, MP3, MP4, or any
device compatible with all of the aforementioned
functions). It can also be associated (paired)
with any Bluetooth
to another Lazer Link, establishing an audio
communication (intercommunication) up to a
distance of approximately 10 metres, maintaining
the association with the mobile or corresponding
device at the same time.
This device can be fully operated with only one
control button (A). A single LED (red/blue) (A1)
is the indicator of its functions: pairing, charging,
on/off, low battery indicator. The Lazer Link weighs
only 55g approximately. In order to get the best
use out of your Lazer Link, please read this manual
thoroughly, and then keep it in a safe place for later
use or visit
http://www.lazerhelmets.com/fr/innovations-2/lazer-link
Before using the Lazer Link for the first time, the
battery (D) must be fully charged. Plug the charger
(F) into the socket, and then insert the other end of
the cable to the Lazer Link mini-USB jack (B)
While the battery is charging the red LED (A1) is on,
and will turn off once it is fully charged.
MEG Lazer Link bichro DEF 2.indd 4
Downloaded from www.Manualslib.com
WELcomE
transmitting devices in HSP, HFP and
audio receiver device, or
®
cHARGING THE LAZER LINK
manuals search engine
NOTE: Never unplug the devices by pulling from the cable.
NOTE: It is recommended to completely charge
the battery each time, this will extend the battery
life time.
NOTE: When the battery is charged completely but
has not been used for a long time, it may have
less energy storage than normal. After being used
and recharged a few times, the energy storage will
®
increase back to normal.
INSTALLING THE LAZER LINK
See the video on "how to install the Lazer Link" on
our website:
http://www.lazerhelmets.com/fr/innovations-2/lazer-link
PAIRING WITH A moBILE oR NAVIGAToR (GPS)
To be able to use the Lazer Link you have to
associate it with the Bluetooth
connect it to (Mobile, GPS, etc). To do this, when
the Lazer Link is switched off, press and keep the
control button (A) pressed until the LED (A1) starts
to flash alternately in Red and Blue. When looking
for Bluetooth devices in the mobile or navigator,
®
you should find the device called "Lazer Link".
Select the "Lazer Link" device and if requested enter
the 0000 access code.
SWITCHING ON / SWITCHING OFF
To switch on your Lazer Link press and hold the
control button (A), until you hear a beep audio
sound in the speaker (C) and the LED (A1) starts to
blink in a blue colour.
To switch off your Lazer Link press and hold the
control button (A) for a couple of seconds, until you
hear a beep sound in the speaker and the LED (A1)
starts to blink in a red colour and then off.
- 4 -
device you want to
®
12/12/12 14:23
ANSW
When
play
To an
into t
press
as yo
the a
phon
To en
wait f
REJEC
To re
the c
acou
MAK
To m
activ
mobi
voice
funct
To m
numb
It als
confi
VOLU
WITH
The L
volum
km/h
devic
to se
with
of th
ADJU