Inhaltsverzeichnis
Werbung
Ethernet-Verbindungsobjekt
Legen Sie mindestens eine Instanz für das Gerät fest, zum Beispiel Instanz 1 als Instanz des CPU-
Ethernet-Interfaces (Class Code 0xF6) von EtherNet/IP.
Tab. 73:
Id
Attribute
0x1 Interface Speed
0x2 Interface Flags
0x3 Physical Address
0x4 Interface Counters
0x5 Media Counters
0x6 Interface Control
UM Config OCTOPUS3
Release 8.0 09/2019
Instanz-Attribute
Access
Rule
Get
Get
Get
Get
Get
Get/Set STRUCT of:
Data type
Description
UDINT
Used interface speed in MBit/s (10,
100, 1000, ...).
0 is used when the speed has not
been determined or is invalid because
of detected errors.
DWORD
Interface Status Flags:
0: Link State (0=No link, 1=Link)
1: Duplex mode (0=Half, 1=Full)
2: Auto-Negotiation Status
3:
4:
5: Manual configuration require reset
6: Hardware error
ARRAY of:
MAC address of physical interface
6 USINT
STRUCT of:
InOctets, InUcastPackets,
InNUcastPackets, InDiscards,
UDINT
InErrors, InUnknownProtos,
MibIICounter1
OutOctets, OutUcastPackets,
UDINT
OutNUcastPackets, OutDiscards,
MibIICounter2
OutErrors
...
STRUCT of:
Alignment Errors, FCS Errors, Single
Collision, Multiple Collision, SQE Test
UDINT
Errors, Deferred Transmissions, Late
EthernetMib
Collisions, Excessive Collisions, MAC
Counter1
TX Errors, Carrier Sense Errors,
UDINT
Frame Too Long, MAC RX Errors
EthernetMib
Counter2
...
WORD ControlBits 0: Auto-negotiation enable/disable
1: Duplex mode (0=Half, 1=Full),
UINT
Interface speed in MBits/s: 10,100,...,
ForcedInterface
if Auto-negotiation disabled
Speed
Industrieprotokolle
16.3 EtherNet/IP
0x0=Auto-Negotiation in progress
0x1=Auto-Negotiation failed
0x2=Failed but speed detected
0x3=Auto-Negotiation success
0x4=No Auto-Negotiation
(always 0 because it is not
needed)
Control Bits:
(0=disable, 1=enable)
if Auto-negotiation disabled
429
Werbung
Inhaltsverzeichnis
