Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
No additional balancing surfa-
ces or holes must be added
to this boring tool!
Max. permitted residual imbalance of
the machine manufacturer has to be
observed (if necessary complete tools
have to be balanced).
5. Operation
Securing the insert holders
5
The slider
is especially profiled to
fixed quick and easy different insert
2
holders
.
Torque for the insert holder screw, see
Technical data page 12.
Reverse machining from Ø 38 mm
(1.496")
For back boring the insert holder is tur-
ned through 180° and mounted on the
slider.
Attention: the reverse machining is
carried out with anti-clockwise spindle
rotation.
2
5
5
7
6
Clamping
To clamp the slider
with a clamping screw
ing metal, this clamping screw
be used to clamp the slider
after each adjustment, the clamping
arrangement must be operated.
7
Graduated dial
located below the tool clamping point.
Only one key is needed to operate both
functions.
To avoid damange to parts of
the adjustment mechanism,
do not make any diameter
adjustments in the
clamped state. Never use
force when carry out adjustment.
Diameter adjustment
The matt chrome dial
reading of the diameter setting. The
distance of the adjustment is limited.
Please follow the sequence of operations
for setting the diameter as set out below.
Example:
1. Slacken clamping screw
2. For the diameter setting, adjust the
tool by turning the dial
- on a tool setting device or
- by carrying out a trial drilling or
gauge cut on the machine.
One revolution of the dial is equivalent
to the slider (and hence also the cut-
ter on the tool) undergoing a diameter
adjustment of 0.5 mm (.025"). One
division on the dial corresponds to a
diameter adjustment of 0.01 mm
(.0005").
metric:
7
English
5
the tool is fitted
6
. When remov-
6
must
5
. Before and
for the adjustment is
7
gives an exact
6
.
7
either
inch:
7
9
Werbung
Inhaltsverzeichnis
