Memory Function - Klarstein Thermaxx Heatstream Handbuch

• The scope of scheduling is for 0-24 hours, and
• Set the appointment time, press the timer button
Timer settings
• Cancel timer: If the scheduling time is set, press the
• After the scheduling is started, press the timer button
• During the scheduled time, the machine is shut down
• When started up the machine again and it will operate

Memory function

• When the indoor ambient temperature Th exceeds
Safety protection
function
• Under the working state, press the standby button
Shut down
press the Plus or Minus button (
to increase or decrease 1 hour. When the set value
is "0H", press the Minus button
"24H". When the set value is "24H", press the Plus
button , and the setting time is "0H". When the set
value is "0H", the scheduling is canceled. When the
set value is not "0H", the scheduling is started.
mode button , or without operation for 5 seconds,
exit scheduling mode.
standby button to enter the standby state and
cancel the scheduling.
to check the remaining time of the appointment
and reset the scheduling time.
or started up under temperature control, and the
scheduled time is always normal, and free from down
time. During the scheduled time, it is cleared in case of
power failure.
according to the status before the last standby.
50 °C under the standby or working state, all outputs
are turned off, the buzzer prompts 10 long beeps, the
digital screen displays „FF" and flashes at 1 Hz for
75 seconds. As long as there is protection, even if the
ambient temperature is less than 50 °C, the running or
operation cannot be resumed, and the operation can
only be performed after the power is turned off and
on again.
on the control panel to enter the standby state.
or ) each time
to set the time for
or
EN
19