Hagen HA-9000R Bedienungsanleitung Seite 23

5.5 Drainage
For continuous operation or unattended operating, please connect the
attached drain hose to the unit.
into a bucket or drain by gravity.
Set the unit in a horizontal

surface and stable position.
Switch off the unit before

operating.
Remove the plug of the water

outlet opening, and keep it in
safe area.
Securely and properly connect

the drain hose and make sure it
is not kinked and clear of
obstruction.
Place the outlet of hose over a

drain or bucket and ensure that
water could freely flow out of the
unit.
Do not submerge the end of

hose into water; otherwise it can
cause "Air Lock" in the hose.
To avoid water spillage:
•
As the negative pressure of condensate drain pan is large, tilt the
drain hose downward toward the floor. It is appropriate that the
degree of inclination should exceed 20 degrees.
•
Straighten the hose to avoid a trap existing in the hose.
Condensate water can be automatically flow
Remove the rubber
sealing plug
Continuous drain hose
(Inner diameter=11mm)
22