Philips S7000 Serie Bedienungsanleitung Seite 24

Using the Quick Clean Pod
Replacing the Quick Clean Pod Cartridge
Do not tilt the Quick Clean Pod to prevent
leakage.
Hinweis: If you use the shaver with shaving foam,
shaving gel or pre-shave products, thoroughly
rinse the shaving heads before you use the Quick
Clean Pod.
Always shake excess water off the shaver before
you place it in the Quick Clean Pod.
1 Place the shaver upside down into the Quick
Clean Pod. The shaver automatically detects
that it is in the Quick Clean Pod.
2 Switch on the shaver to start the cleaning
program.
Each cleaning program takes approximately
one minute. During the cleaning program the
cleaning symbol lights up continuously and the
blue icon pulses.
The shaver handle vibrates twice quickly when
the cleaning program is finished.
3 Let the shaver air-dry completely in the Quick
Clean Pod before storing it.
Replace the Quick Clean Pod Cartridge
immediately when the cartridge replacement icon
on the Quick Clean Pod becomes visible or follow
the table below.
27
Deutsch