Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1. Installation
It is necessary during installation to
observe codes of good practice, to comply
with local requirements and to follow the
installation instructions. The installation
location should be protected against frost
and be easily accessible.
1.1 Assembly (Fig. 1)
1. Thoroughly flush pipework.
2. Close valves 1 and 2 .
3. Install the Y strainer 3
Where possible, fit in horizontal
●
pipework.
Seal plug pointing downwards
●
4. Slowly open valves 1 and 2 .
2. Maintenance
The strainer 5 should be cleaned or
replaced as appropriate for system
conditions.
1. Close valves 1 and 2 .
2. Open seal plug 4 .
3. Remove strainer 5
If this is not done, strainer blockage
●
can occur, resulting in pressure loss
and reducing water flow rate
The strainers are of stainless steel.
●
Red deposits from the pipework do
not affect the function or filtering
efficiency.
5. Reassemble in the reverse sequence.
6. Open valves 1 and 2 .
3. Range of application
Connection sizes:
Medium:
(Fig. 2)
R
/
" to 2"
1
4
Water, oil,
compressed air,
steam and other non-
aggressive mediums.
GB
Operating pressure: Maximum 16.0 bar
Operating
temperature
Installation position: In horizontal or
4. Safety guidelines
1. Use the appliance
In good condition
●
According to regulations
●
With due regard to safety.
●
2. Follow installation instructions
3. Immediately rectify any malfunctions
which may influence safety.
4. FY 32 Y strainers are exclusively for
use in applications detailed in these
installation instructions. Any variation
from this or other use will not comply
with requirements.
5. Replacement parts
① Replacement strainer with Seal ring,
0.25mm mesh size
/
"
ES 32 -
1
4
/
"
ES 32 -
3
8
/
"
ES 32 -
1
2
/
"
ES 32 -
3
4
1"
ES 32 - 1 C
1
/
"
ES 32 - 1
1
4
1
/
"
ES 32 - 1
1
2
2"
ES 32 - 2 C
3
(for water, oil or
compressed air)
Maximum 4.0 bar (for
steam)
Maximum 150 °C.
vertical pipework with
seal plug pointing
downwards.
(Fig. 5)
/
C
3
8
/
C
3
8
/
C
1
2
/
C
3
4
/
C
1
4
/
C
1
2
Werbung
