Repositioning Of The Built-In Control Unit; Heater Stones - Sawo NR-60NB Bedienungsanleitung

Repositioning of the Built-In Control Unit

Reposition of the control unit facing the sides (right, left or center).
Remove the screws of the bottom cover (Fig. 3A).
1.
Loosen the screws holding the control box (Fig. 3B).
2.
Detach the control box from the heating element holder.
3.
Carefully turn the control box to desired position (Fig. 3C).
4.
- Do not pull too much away the control box from the heating element holder so that it will
not damage thermostat sensor and wiring connections (Fig. 10).
Fit the control box back to the heating element holder and tighten the screws.
5.
Close the bottom cover and tighten the screws.
6.

Heater Stones

The main purpose of the stones in the heater unit is to store enough energy to efficiently
vaporize the water thrown on top of the stones to maintain correct humidity in the sauna
room. The stones must be removed at least once a year or every 500 hours which ever
occurs first. All stone crumbles must be removed from the heater unit and replaced
with new ones as described in the heater manual. The required amount of stones is
also listed in the manual provided. See Fig.4.
NOTE! Never use the heater without stones as it may cause fire.
Use only manufacturer recommended SaWo-stones. Using
unsuitable stones may lead to heating element damage and will
void the warranty. Never use ceramic stones or other artificial
stones of any type!
Loading stones into the heater
It is recommended that all stones should be rinsed to remove any stains or
dust that can cause unpleasant odour during the first few times of using the
heater. It is important that the stones are loaded carefully in a way that they
do not block air circulation through the heater. Larger stones that won't fit
between the heating elements must not be forced in place instead they
must be completely removed.
Small crumble or stone pieces smaller than 35mm in diameter must not be
loaded into the heater because they will block the air circulation and will
cause overheating and possible heating element damage.
NOTE! Heating element damage due to overheating
caused by wrong kind of stones or stones which were
wrongly loaded into the heater is not covered by the
factory warranty.
Kuva 4
Fig. 4
KEINE KERAMIKSTEINE
NO CERAMIC STONES
13
DEUT
ENGLISH