AEG MFE 1305 Gebrauchsanleitung Seite 8

Tips
Service
Accessories
ENGLISH
Blunt diamond cutting discs are recognisable by the large number of sparks that fly
during work, and can be resharpened by making a number of cuts in abrasive ma-
terial (e.g. plaster).
When cutting concrete or brick it is recommended to use only one diamond cutting
disk, especially if large cutting depth is required. Otherwise the engine gets over-
loaded, and the motor protection device activates the electronic shut-off.
If the load-rate motor protection switches the machine off very often, it is possible
that the reason for this are power consuming materials like damp or very hard ma-
terials. In this case reduce the cutting depth or work with only one diamond cutting
disc.
If only one disc is fitted it is recommended to use the square between the protective
hood cover and cutting support as aid for cutting. For that purpose a spacing washer
must be mounted between bearing flange and diamond cutting disk (the remaining
spacing washers must be mounted between diamond cutting disk and flange nut).
To faciliate this a guide can be mounted to the wall.
Keep the machine and the ventilation slots clean.
Use only AEG accessories and spare parts. Should components need to be re-
placed which have not been described, please contact one of our AEG service
agents (see our list of guarantee/service addresses).
If needed, an exploded view of the tool can be ordered. Please state the ten-digit
No. as well as the machine type printed on the label and order the drawing at your
local service agents or directly at:
Atlas Copco Electric Tools GmbH, Postfach 320, D-71361 Winnenden.
Please refer to page 2 for range of accessories. Further accessories with part num-
bers are shown in our catalogues.
9 MFE 1305