AEG MFE 1305 Gebrauchsanleitung Seite 2

Introduction
Technical Data
Safety advice
ENGLISH
You demand the best and buy quality - quality provided by Atlas Copco. We have
built for you a reliable and lasting tool. Working effectively and without endangering
your health is only possible if this instruction for use is read carefully before first us-
ing the tool. We want to satisfy our customers and would like you to buy again AEG
Electric Power Tools from Atlas Copco.
Type
Nominal power (W)................................................................................
No-load speed (min
Thread of work spindle
Grinding disk diameter (mm) ................................................................
Cutting depth (mm)................................................................................
Cutting width (mm) ................................................................................
Weight (kg) ............................................................................................
Smooth start ..........................................................................................
No-load speed limiter.............................................................................
Overload protection ...............................................................................
Please pay attention to the safety instructions in the attached leaflet!
Do not pierce the motor housing as this could damage the double insulation (use
adhesives).
Always pull the plug from the mains before making any settings or carrying out main-
tenance.
Only plug-in when machine is switched off.
Keep mains lead clear from working range of the machine. Always lead the cable
away behind you.
Before use check machine, cable, and plug for any damages or material fatigue. Re-
pairs should only be carried out by authorised service agents.
After switching off, the machine will not be idle immediately. (After-running of the
work spindle.) Allow the machine to come to a stop before putting down.
Never reach into the danger area of the machine when it is running.
Always wear safety goggles and ear protectors when working with this machine. It
is further recommended to wear safety gloves, apron, as well as sturdy non-slipping
shoes.
Always keep a safe footing and hold machine with both hands.
Always use the protective shields on the machine.
Always use the additional handle.
Only use the machine with a suitable dust-remover!
Immediately switch off the machine in case of considerable vibrations or if other mal-
functions occur. Check the machine in order to find out the cause.
Always use and store the grinding disks according to the manufacturer's instruc-
tions.
Only use diamond cutting discs that are sharp and in perfect condition. Replace dia-
mond cutting discs at once if they have splits or are deformed. Carry out a test run
without load for at least 30 seconds.
The protective hood of the machine is only suitable for metal-reinforced cutting
discs.
Only use tools whose permitted speed is at least as high as the highest no-load
speed of the machine.
Pay attention to the dimensions of the grinding disc. The mounting hole diameter
must fit the mounting flange without play. Do not use reducer pieces or adapters.
Only use the machine for dry cutting in stone.
3
-1
) ...........................................................................
MFE 1305
1300
9500
M 14
125
8-30
8-26
3.8
•
•
•
MFE 1305