Installation - emmeti Termec Bedienungsanleitung

Installation

The room thermostat must be installed at about 1,5 mt above
the floor, in an area where temperature is usually standard.
Avoid installation in air stagnation areas, near doors, windows,
heat sources, etc.
Proceed as follows for the installation:
• Remove the cover  pressing with a screwdriver on the
blocking hook of the cover and slightly press downwards on
the adjustment knob (Fig. 1).
• Fix the thermostat on the wall by means of dowel screws
(max. 3,5 mm).
N.B. Make sure the wall has no waviness and do not tighten
excessively the fixing screws.
Avoid using the thermostat as a template when making
the fixing holes.
• Pass the connecting wires through the hole on the bottom of
the thermostat and remove the terminal board cover plate .
• Make the electrical connections according to the electrical
diagram on the internal side of the cover, replace the termi-
nal board cover plate.
16
GB