KaWe MASTERLIGHT Classic Gebrauchsanweisung Seite 11

12 V / 35 W or LED
Purpose: The high-quality flexible examination lamp is to be used in me-
dical practices and in medical facilities.
Guarantee: When used properly and with attention to our User's
Manual we guarantee this product for 2 years from the date of purchase. For
further questions or in case of necessary repair work, please contact your
dealer.
Safety instructions: 1. Read user's manual and heed it. 2. The
examination lamp is only to be used in good order and condition.
3. The examination lamp is only to be used on a flat ground. 4. Protect the
mains cable against heat, oil and sharp edges.
CE Marking: This KaWe product meets EC Standards for medical
products 93/42 EC.
Technical Data:
Maximum height: ................................................................ approx. 220 cm
Upper part – swivel range: .................................................... approx. 82 cm
Diameter tripod stand: ........................................................... approx. 70 cm
Weight: ................................................................................... approx. 4.4 kg
Mains voltage: ..................................................... 230 - 240 Volt, 0.5 A max.
Bulb: ............................................................................12 V / 35 W, 5 A max.
LED: ..........................................................................12 V / 10 W, 0.7 A max.
Angle of radiation: ..................................................................................... 8°
Colour temperature: ...................................................... approx. 3200° Kelvin
Admissible operating temperature: .......................... +10° C up to + 40° C
Relative humidity ........................................................... 30 % up to + 75 %
Air pressure ............................................................. 700 hPa up to 1060 hPa
Admissible storage temperature: .............................. - 40° C up to + 80° C
Type of protection: .................................................................................. IP20
Cleaning: 1. The examination lamp is resistant to disinfecting agents, is
abrasion-proof and resistant to urine and blood. 2. The examination lamps
are to be wiped off with a damp cloth and alcohol-based surface
disinfecting agents. 3. Clean soiled rollers in order to avoid static
charge. 4. Do not use any acidic substances.
Maintenance: After long use, retighten the screws, if required.
Storage: Store examination lamp and the mains cable in a dry place.
Common accessories: Further information about these products can be
obtained in our Internet shop at: www.kawemed.de.
Manufacturer: KaWe
Contacting the manufacturer: Address or telephone number of the dealer
or dial +49-7141-68188-0.
Removal: According to the EU Directives this product must be
brought to a collection center for electric and electronic waste.
Subject to technical modifications.
Warning:To prevent the risk of electric shock, this device must be
connected to a circuit breaker
Warning: This device is not to be altered or modified in any way.
Symbol key:
Manufacturer
Date of manufacture
Heed the User's Manual
Warning!
11
Replace the bulb
1. Disconnect the
power plug.
2. Set switch to - 0 -.
3. Unscrew the ring.
4. Remove defective
bulb only after it has
cooled down.
5. Plug in the bulb.
6. Unscrew the ring.
Admissible storage
temperature
Admissible operating
temperature
Separate disposal of electric
and electronic waste
Meets EC Standards
for medical products