Temperature Adjustment Warnings; Temperature Indicator - AEG RCB736D5MB Bedienungsanleitung

Temperature Adjustment Warnings

• It is not recommended that you operate your fridge in environments colder than 10°C
in terms of its efficiency.
• Do not start another adjustment while you are already making an adjustment.
• Temperature adjustments should be made according to the frequency of door openings,
the quantity of food kept inside the fridge and the ambient temperature in the location
of your fridge.
• In order to allow your fridge to reach the operating temperature after being connected to
mains, do not open the doors frequently or place large quantities of food in the fridge.
Please note that, depending on the ambient temperature, it may take 24 hours for your
fridge to reach the operating temperature.
• A 5 minute delay function is applied to prevent damage to the compressor of your fridge
when connecting or disconnecting to mains, or when an energy breakdown occurs. Your
fridge will begin to operate normally after 5 minutes.
• Your appliance is designed to operate in the
ambient temperature (T/SN = 10°C - 43°C) intervals
stated in the standards, according to the climate
class displayed on the information label. We do
not recommend operating your appliance out of
the stated temperature limits in terms of cooling
effectiveness.
Important installation instructions
This appliance is designed to work in difficult climate conditions (up to 43 degrees C or 110
degrees F) and is powered with 'Freezer Shield' technology which ensures that the frozen
food in the freezer will not defrost even if the ambient temperature falls as low as -15 °C. So
you may then install your appliance in an unheated room without having to worry about frozen
food in the freezer being spoilt. When the ambient temperature returns to normal, you may
continue using the appliance as usual.

Temperature indicator

In order to help you better set your refrigerator, we have equipped it with a
temperature indicator located in the coldest area.
To better store the food in your refrigerator, especially in the coldest area, make
sure the message "OK" appears on the temperature indicator. If « OK » does
not appear, this means that the temperature setting has not been done properly.
Since "OK" appears in black, it will be difficult to see this indication if the temperature
indicator is badly lit. To be able to see this indication properly, there should be
enough light.
Each time the temperature setting device is changed, wait for the stabilisation of the
temperature inside the appliance before proceeding, if necessary, with a new temperature
setting. Please change the position of the temperature setting device progressively and wait
at least 12 hours before starting a new check and potential change.
NOTE: Following repeated openings (or prolonged opening) of the door or after putting fresh
food into the appliance, it is normal for the indication "OK" not to appear in the temperature
setting indicator. If there is an abnormal ice crystals build up (bottom wall of the appliance)
on the refrigerator compartment evaporator (overloaded appliance, high room temperature,
Climate class
EN -17-
Ambient (
T 16 to 43 (
ST 16 to 38 (
N
16 to 32 (
SN
10 to 32 (
C)
o
C)
o
C)
o
C)
o
C)
o
OK