Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1
4
5
7
6
3
This product is a speaker stand for the DENON S-302/S-301/S-102 /S-
101 DVD Home Theater. (As of August 2007)
Assembly
• The speaker stand's post has three speaker mount holes allowing
the height of the speaker to be adjusted in three steps. Choose the
desired mount hole.
• Use the included hex wrench to tighten the screws.
NOTE
2
Be careful not to damage the post or speaker with the hex wrench
when tightening the screws.
1
Insert the post into the base.
2
Lower the speaker stand gently and mount it to the
post using the (three) screws.
SC-S302
3
Pass the speaker cable into the post.
Pass the cable through the cut-out part of the base.
4
Attach the spacers to the bracket.
b Attach the spacers evenly above and below the screw section to
prevent the speaker and bracket from touching each other.
5
Line up the screw holes in the bracket and post and
mount the bracket on the post.
b Line up the hole in the bracket with the hole in the post to be used
to fasten by screw and attach.
6
SC-S102
Connect the speaker cables to the speaker.
7
Mount the speaker on the speaker stand.
b Fasten securely using the (two) speaker fixing screws.
b After mounting the speaker, pull the speaker cable the necessary
amount so that there is no slack inside the post.
NOTE
ENGLISH
• When assembling, be very careful not to injury yourself by letting the
speaker stand tip over accidentally or dropping the speaker.
• When assembling, work carefully on a soft blanket or the like so as
not to scratch the speaker, speaker stand or floor.
• Check that none of the screws fastening the speaker are loose.
• Install the speaker stand on a flat, sturdy floor where it will not shake
or tip over.
• When installing, be sure not to place the speaker stand on top of the
speaker cable.
• When moving the speaker stand, disconnect the speaker cables
from the receiver, etc., and hold the post.
Cleaning
D Use a soft cloth to wipe any dirt off the speaker stand.
• When using chemical-impregnated cloths, read the cloth's
cautions.
D Do not use benzene, thinner or other organic solvents or insecticides,
as these could mar or discolor the surface.
Cautions on handling
WARNING
Be sure to check for safety directly after installing, then
conduct safety checks periodically to be sure there is no risk
of falling or tipping. DENON will accept no responsibility whatsoever
for any damage or accidents due to inadequacies in the place or
method of installation.
Specifications
Maximum external dimensions:
Mass:
b For purposes of improvement, specifications and design are subject to change
without notice.
300 (W) x 1022 (H) x 300 (D) mm
Approx. 7 .3 kg/stand
Werbung
Inhaltsverzeichnis
