Troubleshooting; Security Advices - Caso SJW 400 Bedienungsanleitung

8. Clean the juicing barrel with running water and a mild detergent. Open the closure of
juice flow. Clean the opening for residiuals and the juice flow carefully from alle
residuals.
Warning
► Do not use any hazardous chemicals to clean the appliance. It may change the color of
the appliance or result in a fire.
9. After cleaning, use a dry cloth to dry the appliance. Mount it and store it at a dry, safe
place.

17 Troubleshooting

This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:

17.1 Security advices

Attention
► Repairs of electrical appliances must be carried out by qualified personnel who are
trained by the manufacturer.
► Repairs performed by untrained persons may result in considerable hazards for the user
and damage the machine.

17.2 Troubleshooting

Problem
The device does not start.
The amount of juice is very
little and residues are still
damp.
Shutdown during use.
Caso Entsafter „Whole Slow Juicer" SJW 400
Solution
• Please check whether the power plug is properly plugged.
• Please check whether the assembly is done according to
assembly methods.
• Check whether stale food is used.
• Food that was stored in the refrigerator for a long time
must be soaked in clear water for at least 10 minutes
before using them.
• Different ingredients hold different amounts of fluid that will
yield different amounts of juice.
• Check if all parts are assembled correctly.
• If juicing ingredients with small seeds, after a few servings,
it may reduce the juice yield.For best result, disassemble
and wash the top-set (without motor block) in between
juicing.
• If there is seed residue on the bottom of the strainer, this
can affect juicer performance and the overall juice yield.
• Check whether too much food is used.
• Check whether the food contains hard cores.
• When the juicer stops because there are too many
ingredients inserted in it, press the REV(II)-O-ON(I) button
in this order, switching back and forth 2-3 times.
45