Samsung HW-NW700 Bedienungsanleitung Seite 26

4. Press and hold the Up button on the remote control or press the ID SET button on the bottom
panel for at least 5 seconds.
• The ID SET message appears on the display of the Soundbar for a moment, and then disappears.
• The Soundbar will automatically power on when ID SET is complete.
5. Check if the LINK LED is solid blue (connection complete).
Front of the Wireless Subwoofer
NOTES
– Do not connect the power cord of this product or your TV to a wall outlet until all connections
between components are complete.
– Before moving or installing this product, be sure to turn off the power and disconnect the power cord.
– The maximum transmission distance of the wireless signal of the main unit is about 10 meters, but
may vary depending on your operating environment. If a steel-concrete or metallic wall is between
the main unit and the wireless subwoofer, the system may not operate at all, because the wireless
signal cannot penetrate metal.
PRECAUTIONS
– Wireless receiving antennas are built into the wireless subwoofer. Keep the units away from water
and moisture.
– For optimal listening performance, make sure that the area around the wireless subwoofer and
Wireless Receiver Module (Sold separately) is clear of any obstructions.
5 Sec
Stops blinking.
Glows blue.
ENG - 26
ID SET
The LINK LED indicator stops blinking
and glows a solid blue when a
connection is established between the
Soundbar and the Wireless Subwoofer.