Setting A Disc; Place A Disc - Panasonic CF-VCW281 Bedienungsanleitung

Setting a Disc

1
Open the disc tray
Press the eject button and slowly pull out the tray.
2

Place a disc

Place the disc with the label facing upward in the
drive and push down until the center holder clicks.
<Removing a disc>
Place a finger on the center holder and lift up on the
edge of the disc.
3
Close the disc tray
E
Close the tray without touching the eject button.
CAUTION
Do not apply excessive force to the tray in the open position, doing so could damage
the tray.
<Using PC Cards>
If the PC Card does not work, there may be no interrupt request (IRQ) line available.
Deactivate unnecessary equipment using in the Setup Utility.
NOTE
References to "CD/DVD" in the Setup Utility will not change when the CD-R/RW
Drive Pack is installed.
If the vibration of the CD-R/RW drive is excessively high, set [CD/DVD Drive Speed]
in the Setup Utility to [Low].
8
Label side up
Center Holder
Eject Button