Etherma LAVA ARCUS Montage- Und Gebrauchsanleitung Seite 12

N O T E S
IMPORTANT NOTES:
› ETHERMA LAVA design infrared heating devices comply
®
with the relevant safety requirements.
› Installation and initial start-up, as well as repairs and servic-
ing, may be carried out by a licensed specialist or qualified
individual only. All safety regulations must be observed. This
person must verify first whether the electrical in-house
system complies with the relevant standards. The respon-
sibility of the manufacturer is limited to supply of the device.
› Comply with country-specific safety regulations.
› Comply with local safety precautions.
› The devices are suitable for the installation on walls and on
ceilings.
› Protective areas must be observed in accordance with DIN
VDE 0100, part 701, when installing the device in bathrooms.
› Minimum distances must be adhered to.
C L E A R A N C E S
INSTALLATION AND MINIMUM DISTANCES:
LAVA design infrared heating devices have to be mounted
®
so that flammable objects cannot catch fire. Be absolutely sure
to comply with minimum clearances, in particular to highly
combustible objects such as curtains, upholstered furniture,
etc. Please also make sure that the infrared heater can radiate
freely into the room.
ATTENTION: Strain of any kind on the surface,
whether from persons or objects leaning against
it or from other forces, must be avoided!
12
NOTE
In case of a ceiling installation, the device must be mounted at
least 1.8 m above the floor.
NOTE
In bathrooms, the device must be mounted so that switches or
other regulators cannot be touched by persons in a bathtub or
shower.
NOTE
Due to the low surface temperature at the rear side (up to
40 °C) the infrared heating may also be mounted on wooden
panelling.
NOTE
The device is not intended for the use in wardrobes and be-
neath church benches.
35 mm
Dimensional drawing:
minimum mounting clearances
35 mm
35 mm
35 mm