ClimaLine PANCAKE 1 Montageanweisungen Seite 2

S t e p A – A s s e m b l y o f v i b r a t i o n d a m p e r s
For n ew i n s ta l lati on of h eati ng pu mp
The drainage pan needs space between the stand and
the heating pump. Start therefore by securing the vibration
dampers in the ground stand/wall attachment, where the
heating pump's feet are to stand. Lower the bottom rod of
the vibration damper into the stand and tighten it with the
help of a flat washer and a nut - do this with all the vibration
dampers. IMPORTANT! The thick vibration dampers should
be fitted on the RIGHT side of the stand.
Fo r ret ro f i tt e d to an ex i st ing h eat pump
First remove the heating pump's existing vibration dampers
1
at the marking
lowering the bottom rod of the vibration damper into the
ground stand/wall attachment and tightening it using a flat
washer and a nut; tighten the nuts moderately.
Do the same with the vibration damper next to the marking
2
. Do the same on vibration dampers
do not tighten the nuts on the top before the tray is in place
under the drainage pump.
S t e p B – F i x i n g t h e s t r a i g h t t r a y a d a p t e r
Before you place the drainage tray on the stand, fix the tray adapter in the
tray. It is IMPORTANT that the washer is on the TOP of the drainage tray.
Tighten the adapter with the locking screw (by hand).
Note: If the tray has a tray adapter with a basket, see step 'D'.
S t e p C – A s s e m b l y o f t h e h e a t i n g t r a y
F or n e w in s ta ll at io n of h eati ng pump
Place the Pancake between the vibration dampers on
the wall/ground stand or on the consoles, with the
tray adapter at the back and the cable to the right.
2
and fit the new vibration dampers by
3 4
and , but
Thin
1 2
4
3
Thick