Layout And Items Supplied - EINHELL BT-CD 12-2 Li Set Originalbetriebsanleitung

Protection from environmental infl uences
1. Wear suitable work clothes. Wear safety
goggles.
2. Protect your cordless tool and the battery
charger from moisture and rain. Moisture
and rain can cause dangerous cell damage.
3. Do not use the cordless tool or the battery
charger near vapors and infl ammable liquids.
4. Use the battery charger and cordless tools
only in dry conditions and an ambient
temperature of 10-40°C.
5. Do not keep the battery charger in places
where the temperature is liable to reach over
40°C. In particular, do not leave the battery
charger in a car that is parked in the sunshine.
6. Protect batteries from overheating.
Overloads, over-charging and exposure to
direct sunlight will result in overheating and
cell damage. Never charge or work with
batteries which have been overheated –
replace them immediately if possible.
7. Storage of batteries, battery chargers
and cordless tools. Store the charger and
your cordless tool only in dry places with an
ambient temperature of 10-40°C. Store your
lithium-ion battery pack in a cool, dry place at
a temperature of 10-20°C. Protect them from
humidity and direct sunlight. Only place fully
charged batteries in storage (charged at least
40%).
8. Prevent the lithium-ion battery pack from
freezing. Battery packs which were stored
below 0°C for more than 60 minutes must be
disposed of.
9. When handling batteries beware of
electrostatic charge: Electrostatic discharges
cause damage of the electronic protection
system and the battery cells. Avoid
electrostatic charging and never touch the
battery poles.
Anl_BT_CD_12_2_Li_SPK7.indb 21 Anl_BT_CD_12_2_Li_SPK7.indb 21
GB
Rechargeable batteries and cordless electric
machines and tools contain materials that are
potentially harmful to the environment. Never
place any cordless electric machines or tools in
your household refuse. When cordless electric
machines or tools become defective or worn,
remove the rechargeable batteries and return
them to iSC GmbH (address: Eschenstrasse 6,
D-94405, Germany). If the rechargeable batteries
cannot be removed, return the complete cordless
machine or tool.
You can then be sure that the equipment will be
correctly disposed of by the manufacturer.
When shipping or disposing of batteries and
cordless tools, always ensure that they are
packed individually in plastic bags to prevent
short circuits and fi res.
Do not lose these safety instructions

2. Layout and items supplied

2.1 Layout (Fig. 1)
1. Torque adjustment (setting ring)
2. Quick-change drill chuck
3. Changeover switch
4. On/Off switch
5. Battery
6. Charging unit
7. Charging adapter
8. Pushlock button
9. Selector switch for 1st/2nd gear
- 21 -
28.05.2018 14:44:05 28.05.2018 14:44:05