Electronic Speed Controller (Esc); Factory Defaults - Arrma Granite 4x4 550 MEGA Handbuch

ND
Motor Connectors
Battery Plug
ESC Specifications
Input Voltage
ESC Status LED
Low Voltage Cut Off

Factory Defaults

OM

Electronic Speed Controller (ESC)

If using LiPo batteries you must set the correct battery mode on the ESC
(electronic speed controller) to prevent battery damage.
Setting 'Jumpers'
Throttle Setup
Do not move the throttle when switching the model on as the ESC will
automatically set the throttle neutral. A long beep will sound to confirm
setup.
6-7 NiMh (7.2-8.4v) / 2S Lipo (7.4v)
LED off: Neutral throttle
LED blinking slowly: Partial Forward/Reverse/Brake
LED solidly on: Full Forward/Reverse/Brake
Battery Mode
Cut-off Voltage
Heat-sink
HEAT-SINK MAY BE HOT AFTER USE
Power Switch
BEC Output
NiMh
4.5v
Battery Mode: NiMh
Reverse: On
19
Receiver Plug
(CH2)
6.0v/2A Max
LiPo
6.4v
WWW.ARRMA-RC.COM